LEDSON EPIX14+ Work Strobe LED bar 14" 120W

Light up the work area and make the vehicle easier to spot.

The EPIX14+ Work Strobe pairs a broad work-light beam with an amber warning function, ideal for builds where a long-range driving beam isn't the priority.

What's special about this light?

The LEDSON EPIX14+ Work Strobe LED bar (SKU 334915084) combines a broad work-area flood light with an amber warning strobe and a separate integrated position-light function. This is the 120° work-light model, not the long-range EPIX Prime driving-beam version.

Lighting functions

• 120W (8 × 15W LEDs) wide-angle work light
• 7,300 actual lumens, 119m at 1 lux, 120° flood beam
• 5000K neutral-white work lighting
• Dynamic integrated position-light effect; selectable red or yellow/amber output
• 10 selectable strobe patterns, including an ECE R65-approved pattern
• Manufacturer-listed ECE R148 (position), R65 (warning) and R10 (EMC)
• Supports a reduced-power Eco mode using LEDSON E-screw part 334915020

Electrical and physical specifications

• Operating voltage: 9–36V DC
• Full power consumption: approximately 7.1A at 12V / 3.5A at 24V for work light function
• Dimensions: 357 × 43 × 61mm (excluding bracket)
• Weight: approximately 1.2kg
• IP69K ingress resistance; aluminium housing and polycarbonate lens
• Connection: 6-pin Deutsch DT

What's included?

• 1 × EPIX14+ Work Strobe LED bar
• Mounting brackets, screws, bolts and installation instructions
• Integrated 6-pin DT lamp connector (a compatible external harness is required separately)

Fitting advice and limitations

LEDSON recommends its Connect 6-pin DT harness (7801006) for suitable 12V applications; check the correct 12/24V wiring arrangements for your vehicle. The strobe and work-light modes have interlocked behaviour described in the manufacturer instructions. The work light is not ECE R23 reversing-light approved, even though it can illuminate the area behind a vehicle; do not treat the R65 warning approval as reversing-light approval.

Fit with fused supply, protected wiring and rigid mounting. Ensure any flashing or position lighting is used only where permitted. D.Y Fleet Installations can advise on fitting.

Planning your lighting upgrade? Check the selected model's beam pattern, wiring, mounting dimensions and road-use approvals before ordering. D.Y Fleet Installations can advise on a suitable setup or installation.